La Crosse Technology WS7034UITCA Manuel D'instructions page 17

NOTE: You must insert the batteries into the second sensor within 30 seconds of reception of the first
sensor.
6. The outdoor temperature from the second sensor and the "channel 2" icon should then be
displayed on the Temperature station. If this does not happen after 2 minute, the batteries will
need to be removed from all the units and reset from step 1.
7. Insert the batteries to the third sensor as soon as the "channel 2" icon and outdoor data are
displayed on the Temperature station. Then within 2 minutes, the channel 3 outdoor data from the
third sensor will be displayed and the channel icon will shift back to "1" once the third transmitter is
successfully received. If this is not happen, user shall restart the setting up from step 1.
NOTE: You must insert the batteries into the third sensor within 30 seconds of reception of the second
sensor.
IMPORTANT: Transmission problems will arise if the setting for multiple sensors is not followed as
described above. Should transmission problems occur, it is necessary to remove the batteries from all
units and start again the set-up from step 1.
All manuals and user guides at all-guides.com
15