La Crosse Technology WS7034UITCA Manuel D'instructions page 16

ADDING ADDITIONAL REMOTE SENSORS (OPTIONAL)
The WS-7034U is able to receive signals from 2 additional temperature sensors . The following are
instructions for the set-up of temperature sensor units with the WS-7034U. These extra sensors can be
purchased through the same dealer as this unit.
1. Remove all the batteries from the receiver and sensor(s) and wait 60 seconds. During these 60
seconds, press any button 20 times to discharge any excess power.
2. Insert the batteries to the first temperature sensor.
3. Within 2 minutes of powering up the first sensor, insert the batteries to the Temperature Station.
Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature and the time as 12:00 will be displayed. If they are not shown in LCD after 60
seconds, remove the batteries and wait for at least 60 seconds before reinserting them.
4. The outdoor temperature from the first sensor (channel 1) should then be displayed on the
Temperature station. If this does not happen and the signal reception icon is not shown, after 2
minutes, the batteries will need to be removed from both units and reset from step 1.
5. Insert the batteries to the second sensor as soon as the outdoor temperature readings from the
first sensor are displayed on the Temperature station.
All manuals and user guides at all-guides.com
14