Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6 Basic default settings
HANDSET Unit
Handset number: 1
Handset Name: Handset 1
Phonebook: void
Automatic answer: Off
List of received/no answer/made calls: void
Selected Base: 1
Handset PIN code: 0000
7 Installation
Phase 1: connecting the base
1)
Locate the connectors for the plug-plug telephone cord (Line ) and the power supply cable (Power), as illustrated below.
2)
Plug the jack of the power supply cable in the suitable socket (Power ) then plug the power supply in a wall electric socket located
in the vicinity of the base.
3)
Plug the jack of the telephone cord in the suitable socket (Line) then plug the other end of the cable directly in the wall socket or
use a suitable telephone socket (not provided with the equipment and not displayed in the figure below).
NOTE:
The telephone is able to operate equally upon either performing the connection to the telephone line using a specific
telephone plug (not provided with the equipment and not displayed in the figure below), or using the sole plug-to-plug
telephone cord directly plugging it into a modular jack (wall socket); in both connection modes, the telephone will always
result in a parallel connection to the line.
Phase 2: insert the battery into the handset
Remove the plastic shell from the rear side of the handset, exerting a light pressure with both hands on the opening hole, as
illustrated below.
Insert the battery as illustrated in the figure above, taking care that the polarities reported on the battery label are visible and aimed
upward. Then close the handset.
To verify the correct installation of the battery, switch on the handset by keeping the key
Select the desired language for menu visualization by choosing among those proposed on the display and press OK. Later, to
change the language of the menus at any time, refer to chapter 17 (section "Menu language") in this manual.
For your safety and for a good functioning of the cordless use only the rechargeable battery provided with the product or a battery
of the same type. Also refer to the safety rules reported in the paragraph "Safety notes and product's care" in this manual.
User Manual mod.
tto_guida_22072011_v.indd 15
BASE Unit
Base PIN code: 0000
Flash Time (R key): 98 ms
Pause duration: 2 seconds
Predefined associated handset: Handset 1
Use exclusively the power supply provided, which must
remain always plugged into the power supply socket.
In case another cable has been purchased in a shop,
ensure that the connections are identical to those of the
cable provided.
pressed for 1 second.
5
25/07/2011 11:12
Publicité
Table des Matières
