Sauder Dakota Pass 418540 Instructions D'assemblage page 18

Step 14
We recommend using the SAFETY BRACKET (1G) for added stability. Use a BLACK
å
9/16" LARGE HEAD SCREW (1S) into the top of the unit and a BLACK 1-7/8" FLAT
HEAD SCREW (2S) into a stud in your wall.
Apply the WARNING LABEL (1L) to the TOP (D). You should be able to read the label
å
when the TV is removed from the unit. When the TV is in place, it should hide the
label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once
å
applied, do not try to remove it.
BLACK 1-7/8" FLAT HEAD SCREW
(1 used into a stud in your wall)
BLACK 9/16" LARGE HEAD SCREW
(1 used into the top of your unit)
WARNING
Never use this furniture with a TV
that is too large or too heavy. Severe
injury or death can occur. The TV and
furniture will be unstable and may tip.
-The TV must weigh less than 50 lbs.
-The base of the TV must be able to
sit completely on this shelf.
Refer to instruction book for
complete safety information.
Note: This is a permanent label. Do
not try to remove. Surface will be
damaged.
08/05 2 6 9 2 2 0
Page 18
2S
1S
269220
1G
1L
D
418540 www.sauder.com/services