Sauder Dakota Pass 418540 Instructions D'assemblage page 16

Step 12
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
Make equal margins along all four edges of the BACK (F).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C).
Page 16
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(43 used in this step)
These holes must line up
over the UPRIGHT (C).
F
418540
1N
NAIL
www.sauder.com/services