HON 107 Corner Unit Mode D'emploi page 4

Illustration 10
Minifix cam
Left end panel
Minifix cam
Illustration 11
Shoulder
Reveal
242-0082C
www.hon.com
Arrow
Minifix bolt
Dowel
©2015 The HON Company | HON is a registered trademark of HNI Technologies, under license to the HON Company.
10. Refer to Illustration 10. With arrows facing right end
panel, install three minifix cams (from hardware pack)
into holes along side edge, facing right end panel, of
left end panel.
Use the Phillips screwdriver to tighten minifix cams.
Turn minifix cams clockwise to tighten.
Right end
panel
11. Refer to Illustration 11. Lay top, with holes up, on card-
board or a carpeted surface.
Use the rubber mallet to install four dowels (from hard-
ware pack) onto top as shown.
Use the Phillips screwdriver to install fourteen minifix
bolts (from hardware pack) into holes along front edges
of top. Tighten each minifix bolt until minifix bolt shoul-
der is flush against surface of top.
Minifix bolt
Top
4 of 5