HON 107 Corner Unit Mode D'emploi

Illustration 1
Dowel
Right end
panel
Minifix bolt
Illustration 2
Brace panel
Minifix bolt
Illustration 3
Minifix cam
Brace panel
242-0082C
www.hon.com
Minifix bolt
Top
Right end
panel
Right side of panel
Minifix cam
Arrow
Right end panel
©2015 The HON Company | HON is a registered trademark of HNI Technologies, under license to the HON Company.
Read all instructions and review illustrations before
Shoulder
installing.
Tools required for assembly:
Phillips screwdriver
This assembly includes:
(1) Top
(1) Right end panel
(2) Brace panel
(1) Left end panel
(2) Reveal
Wood products are heavier than they appear and
may be hard to control when moving. Use two or
more people when moving wood products or severe
personal injury may result.
Heavy panels can pinch or crush fingers. Do not
place fingers between or under panels during
assembly.
Top
Assembly:
1. Refer to Illustration 1. Lay right end panel, with holes
up, on cardboard or a carpeted surface.
Use the rubber mallet to install four dowels (from hard-
ware pack) onto right end panel as shown.
Use the Phillips screwdriver to install six minifix bolts
(from hardware pack) onto right end panel. Tighten
each minifix bolt until minifix bolt shoulder is flush
against surface of right end panel.
2. Refer to Illustration 2. Attach a brace panel onto
right side of right end panel by inserting minifix bolts,
attached to right end panel, into holes drilled into side
of right brace panel.
Ensure the set of three holes in top edge of right brace
panel are facing the same direction as the top edge of
right end panel.
3. Refer to Illustration 3. With arrows facing right end
panel, install three minifix cams (from hardware pack)
into holes along side edge, facing right end panel, of
brace panel.
Use the Phillips screwdriver to tighten minifix cams.
Turn minifix cams clockwise to tighten.
107 Corner Unit
Rubber mallet
(6) Glide
(10) Dowel
(23) Minifix bolt
(23) Minifix cam
WARNING
1 of 5