Publicité
Les langues disponibles
Les langues disponibles
Illustration 4
Brace panel
Illustration 5
Dowel
Left end
panel
Illustration 6
Brace
panel
Left end
panel
242-0082C
www.hon.com
Glide
Glide insert
Right end panel
Shoulder
©2015 The HON Company | HON is a registered trademark of HNI Technologies, under license to the HON Company.
4. Refer to Illustration 4. Thread a glide (from hardware
pack) into each glide insert (from hardware pack) by
turning glide clockwise until glide is flat against insert.
Locate holes in bottom edge of right end and brace
panels. Use the rubber mallet to install a glide/glide
insert assembly into each hole.
After glides are fully installed, set panels upright.
5. Refer to Illustration 5. Lay left end panel, with holes up,
on cardboard or a carpeted surface.
Minifix bolt
Use the rubber mallet to install two dowels (from hard-
ware pack) onto left end panel as shown.
Use the Phillips screwdriver to install three minifix bolts
(from hardware pack) onto left end panel. Tighten each
minifix bolt until minifix bolt shoulder is flush against
surface of left end panel.
6. Refer to Illustration 6. Attach remaining brace panel
Top
onto left end panel by inserting minifix bolts, attached
to left end panel, into holes drilled into side of left brace
panel.
Ensure the set of three holes in top edge of left brace
panel are facing the same direction as the top edge of
left end panel.
Minifix bolt
Top
2 of 5
Publicité
