Publicité
Step 15
1
J
D212
å
Pull the DRAWER FRONT BRACKETS (8G) apart and slide them
into the grooves in the DRAWER SIDES (D212 and D213). You
may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
"LH" for easy identifi cation.
å
Fasten the DRAWER FRONT (J) to the DRAWER FRONT
BRACKETS (8G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M65) to the DRAWER
å
FRONT (J). Tighten one HIDDEN CAM.
www.sauder.com/service
Push down
8G
D213
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Hidden part using
recycled material.
Color may vary.
M65
J
VIEW THE T-SLOT BOX VIDEO
2
1S
D212
Slide the DRAWER BOTTOM (D975) into the grooves in the
å
DRAWER SIDES
4
D212
M65
Fasten the DRAWER BACK (D166) to the DRAWER
å
SIDES (D212 and D213) and DRAWER BRACE (M65).
Use fi ve BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other drawer.
å
419517
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D975
U n fi
n i s h
e d
s u r
f a c
e
J
D213
and DRAWER FRONT (J).
(D212 and D213)
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
D166
(10 used in this step)
D166
D213
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 19
Publicité
