Sauder 419517 Mode D'emploi page 16

Step 12
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (F) and lay it over your unit.
First, make equal margins along the top and bottom
å
edges of the BACK (F). Then, make equal margins along
the side edges of the BACK (F). Push on opposite corners
of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick
å
the FELT DISC on the LEGS (H and I).
I
H
Page 16
1M
419517
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(39 used in this step)
These holes must line up
over the UPRIGHT (C).
F
I
H
1N
NAIL
www.sauder.com/service