Sauder 420568 Mode D'emploi page 9

Step 4
Fasten the BOTTOM SUPPORTS (B3) to the ENDS (EE2).
å
Use eight SILVER 1-1/8" FLAT HEAD SCREWS (10S).
Fasten the SMALL SLATS (J2) to the BACK PANEL (I3)
å
and UPPER FRONT PANEL (G3). Use twelve SILVER 1-1/8"
FLAT HEAD SCREWS (10S).
NOTE: Use the exact holes shown.
å
Edge with no holes
EE2
www.sauder.com/service
Edge with no holes
J2
EE2
B3
SILVER 1-1/8" FLAT HEAD SCREW
If the BOTTOM SUPPORTS (B3) or
SMALL SLATS (J2) have a fi nished
J2 surface, it should be facing up.
G3
Finished edge
I3
B3
420568
10S
(20 used in this step)
J2
J2
Edge with no holes
Finished edge
Page 9