Publicité
Step 7
First, fi ll the hole in the short edge of the UPRIGHT (C3) 1/4 to 1/2 full
å
with GLUE (54M). Then, insert a WOOD DOWEL (15F) into the hole.
Wipe away the excess GLUE.
Next, fi ll the two holes in the other short edge of the UPRIGHT (C3) 1/4
å
to 1/2 full with GLUE. Then, insert two WOOD DOWELS (15F) into these
holes. Wipe away the excess GLUE.
Now, fi ll the holes in the BACK PANEL (I3) 1/4 to 1/2 full with GLUE. Be
å
sure to fi ll the second and fourth holes from the top edge as shown.
Fasten the UPRIGHT (C3) to the BACK PANEL (I3). Tighten two
å
HIDDEN CAMS. Wipe away the excess glue.
NOTE: Be sure the WOOD DOWELS in the UPRIGHT insert into the
å
holes in the BACK PANEL.
54M
Maximum
210 degrees
Minimum
190 degrees
Page 12
C3
15F
Arrow
I3
These holes
must be here.
S u r
f a c
e w
H I D
i t h
D E N
C A
M S
15F
420568
Fill the holes 1/4 to 1/2 full with GLUE.
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Roller end
www.sauder.com/service
Publicité
