Sauder 423400 Mode D'emploi page 11

Step 7
Unfold the SMALL BACK (Q) and lay it over the bottom of
å
your unit.
Make equal margins along all four edges of the SMALL
å
BACK (Q). Push on opposite corners of your unit if needed to
make it "square".
Fasten the bottom and side edges of the SMALL BACK (Q) to
å
your unit using the NAILS (6).
NOTE: Do not fasten the upper edge of the SMALL BACK at
å
this time.
Repeat this step for the LARGE BACK (P).
å
NOTE: The LARGE BACK (P) will overlap the SMALL BACK (Q).
å
Do not fasten NAILS along this
edge until the LARGE BACK (P) is
overlapping the SMALL BACK (Q).
423400
Q
www.sauder.com
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(46 used in this step)
P
The LARGE BACK (P) will
overlap the SMALL BACK (Q)
along the SHELF (G).
P
Q
G
6
Page 11