Sauder 419607 Mode D'emploi page 16

Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the outer end of the slot as
shown in the diagram. If it isn't, loosen the mounting screw
to slide it against the end of the slot. Then tighten the
mounting screw.
Fasten the LEFT DOOR (K) to the LEFT END (B) as shown
å
in the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a PULL (12K) to the LEFT DOOR (K). Use two GOLD
å
1" MACHINE SCREWS (50S).
Peel the FELT DISC from the FELT DISC CARD (1M). Stick a
å
FELT DISC on the LEFT DOOR where it comes into contact
with the UPPER SHELF (D) and LARGE UPRIGHT (H).
Repeat this step for the RIGHT DOOR (J).
å
See the next step for DOOR adjustments.
å
GOLD 1" MACHINE SCREW
(4 used for the PULLS)
Page 16
1M
K
12K
1M
50S
B
H
419607
Mounting
screw
Hinge
D
www.sauder.com/services
Slot