Technical Features - GYS DRAW ALIGNER PRO Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Operating manual

SAFETY WHEN USING AND MOVING

Be aware of the risks when using the PRO PULLING BRACKET. Before beginning to pull, always check the

stability of the PRO PULLING BRACKET. If you are using the support arms, make sure they are firmly in place

against the underbody or wheel. With the plate under the wheel, ensure that the vehicle rests correctly on the

plate. Never stand behind the chain when it is under tension. If it comes off, there is a high risk of injury.

This drawing bracket is intended to be used for straightening cladding plates. This bracket must not be used on structural components

(sleeper blocks, B pillars, lower-body reinforcements), as these elements are made of high-strength, high-tensile steel and require a

very high pulling force. Any damage to the product resulting from use that does not follow these recommendations will not be covered

by the warranty.

Do not position the pump vertically as this may cause the pump to be deflated.

Always place the pump on the ground when in use.

Do not stand behind the drawbar when it is in operation. Risk of serious injury.

MAINTENANCE

In order for the product to work at its best, it is important to perform regular maintenance according to the instructions below. The

frequently that maintenance is carried out is based on normal use and a daily usage of eight hours. For more intensive use, the

maintenance should be carried out more frequently.

- Check the condition of the chain and the pulling claw,

- Check the parts for possible cracks or wear,

- Check that the bolts are tight,

- Check the pump hose for damage,

- Check the oil level and top up if necessary,

- Check the tightness of the hydraulic connections.

MAINTENANCE

Dusting can be done with an air gun before cleaning. Wash the PRO PULLING BRACKET with a product suitable for painted, steel

surfaces. Follow the cleaning product's instructions. After cleaning, wipe the PRO PULLING BRACKET with a cloth. Never use a

high-pressure sprayer as this can damage the paint.

TROUBLESHOOTING

Providing that the maintenance instructions have been followed, the PRO PULLING BRACKET is designed for safe and effective

useage. However, if you do encounter any operating problems, here is some advice. If problems persist, contact the repairer or the

manufacturer.

If the PRO PULLING BRACKET's arm does not move when you operate the hand pump:

- Check that the pump's control knob is fully tightened,

- Check that there is enough oil in the pump,

- Check that the pump is correctly connected to the jack cylinder.