The Nylon Cutting Head - Makita ER2650LH Instructions D'emploi D'origine

Masquer les pouces

Table des Matières

Les langues disponibles

At times, such as winter, when starting the engine

is difficult

Operate choke lever with the following procedure when starting engine.

•

After implementing startup steps 1) to 3), set choke lever to the CLOSE

position.

•

Implement startup step 4) and start engine.

•

Once engine starts, set choke lever to the OPEN position.

•

Implement startup step 5) and complete warm up.

CAUTION: If a bang (explosive sound) is heard and the engine stops, or

the just-started engine stalls before the choke lever is operated,

return the choke lever to the OPEN position, and pull the starter

knob a few times again to start the engine.

CAUTION: If the choke lever is left in the CLOSE position, and the starter

knob merely pulled repeatedly, too much fuel will be sucked in,

and the engine will become difficult to start.

STOPPING

1) Release the throttle lever (2) fully, and when the engine rpm has lowered,

set the I-O switch to STOP the engine will now stop.

2) Be aware that the cutting head may not stop immediately and allow it to

slow down fully.

ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)

When it is necessary to adjust the low-speed rotation (idling), perform it by the carburetor adjusting screw.

CHECKUP OF LOW-SPEED ROTATION

–

Set the low-speed rotation to 3,000 min

If it is necessary to change the low speed rotation (idle) speed, use a phillips

head screw driver on the screw illustrated on the right.

–

Turn the adjusting screw to the right, and the engine rotation will increase.

Turn the adjusting screw to the left, and the engine rotation will drop.

–

The carburetor is generally adjusted before shipment. After several tanks of

gasoline the idle rpm may need to be readjusted.