Braun 5 Serie Mode D'emploi page 10

Manual cleaning of the shaver
Regular cleaning ensures better shaving
performance. Rinsing the shaver head under
running water after each shave is an easy and fast
way to keep it clean.
• The hand-held unit should be detached from the
power supply cord before cleaning.
• Switch the shaver on (cordless) and rinse the
shaver head under hot running water until all
residues have been removed. You may use liquid
soap without abrasive substances. Rinse off all
foam and let the shaver run for a few more
seconds.
• Next, switch off the shaver, press the release
button (2) to remove the Foil & Cutter cassette (1)
and let it dry.
• If you regularly clean the shaver under water, then
once a week apply a drop of light machine oil on
top of the Foil & Cutter cassette.
Alternatively, you may clean the shaver with a brush:
• Switch off the shaver. Remove the Foil & Cutter
cassette (1) and tap it out on a flat surface. Using
the brush, clean the inner area of the pivoting
head. Do not clean the cassette with the brush as
this may damage it!
Model 5040s only: The shaver should be cleaned
after each foam usage.
Clean&Charge Station
models 5090cc/5070cc/5050cc only
The Clean&Charge Station has been developed
for cleaning, charging, lubricating, disinfecting and
storing your Braun shaver.
Important
• Only use the power supply special electric cord
set supplied with the shaver.
• In order to avoid any leakage of the cleaning fluid,
place the appliance on a flat, stable surface.
Do not tip, move suddenly or transport in any way
if a cleaning cartridge is installed.
• Do not place the appliance in a mirror cabinet,
nor store it over radiators, nor place it on polished
or lacquered surfaces. Do not expose to direct
sunlight.
• The appliance contains flammable liquid. Keep it
away from sources of ignition. No smoking.
• Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill cartridge.
12 Station power socket
13 Lift button for cartridge exchange
14 Station-to-shaver contacts
15 Clean&Charge Station display
15a Status light
16 Start button
17 Cleaning cartridge
10
Installing the Clean&Charge Station (see fig. D)
(s. fig. B/C)
• Remove the protection foil from the Clean&Charge
Station display.
• Using the special cord set (10), connect the
station power socket (12) to an electrical outlet.
• Press the lift button (13) at the rear side of the
Clean&Charge Station to lift up the housing.
• Hold the cleaning cartridge (17) down on a flat,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base
of the station until it snaps into place.
• Slowly close the housing by pushing it down until
it locks.
Charging the shaver in the Clean&Charge Station
(see fig. D)
Insert the shaver head down into the cleaning station.
Important: The shaver needs to be dry and free
from any foam or soap residue!
The contacts (7) on the back of the shaver need to
align with the contacts (14) in the station. Push the
shaver in the correct position.
A beep sound confirms that the shaver sits properly
in the station. Charging will start automatically.
Model 5090cc: The Clean&Charge Station analyzes
the hygiene status. The status is shown by the
cleaning program indicators
Station display (15) more details see chapter
«Cleaning programs» below.
Cleaning the shaver (see fig. D)
When the cleaning indicator
display, insert the shaver into the Clean&Charge
Station, upside down and with the front showing (with
released head lock/contact alignment/beep sound).
Cleaning programs
5090cc: The hygiene status will be analyzed and one
of the following program indicators will light up.
5070cc/5050cc: One standard cleaning program
included.
Start automatic cleaning
Start the cleaning process by pressing the start
button (16). If status light (15a) does not shine
(Clean&Charge Station switches to stand-by after
ca. 10 minutes), press start button twice. Otherwise
cleaning will not start. For best shaving results,
we recommend cleaning after each shave.
in the Clean&Charge
lights up in the shaver
short economical cleaning
normal level of cleaning
high intensive cleaning