How To Control Your Ac - TCL 5K UN Mechanical Window AC Mode D'emploi

5.
Plug the unit into the electrical outlet as specified above in the electrical requirements.
Move the control to the COOL mode.

How to Control Your AC

All the basics you need to know to stay cool!
1. Power – Turn on the unit by rotating the MODE dial to the desired setting.
2. Cooling Mode – For maximum cooling, set the MODE dial to
will automatically go to high. This will circulate the air throughout the room.
3. Fan Mode – For fan only modes choose either
room in fan mode.
4. Thermostat – Turn the TEMP dial to set the desired room temperature. For maximum cooling,
turn the TEMP dial to "7" (Max Cool).
5. Directional Vents – To direct the air flow, use the horizontal lever to control the horizontal
(sideways) motion, and move the air deflector to control the vertical (up/down) direction.
6. Minimize Wear and Tear – To minimize wear and tear, wait at least 3 minutes before
changing MODES. This will prevent the compressor from overheating and the circuit
breaker from tripping.
7. Filter – It is recommended you clean your filter monthly.
Remove the filter by sliding it out of the front right side of
the air conditioner. Gently wash it with a mild dish washing
detergent and let dry completely before reinstalling it into
the AC.
Normal Operating Sounds
You may hear a pinging noise, caused by the water hitting the condenser on rainy days, or when the
humidity is high. This design feature helps remove moisture and increase efficiency.
You may hear the thermostat click when the compressor cycles on and off. Water will collect in the
base pan on rainy days, or high humidity days. The water may overflow and drip from the unit on
the outside. The fan may run, even when the compressor is not on.
4d.

. In HIGH COOL mode, the fan
, or . The air conditioner will not cool the
10
Remove filter