Chapter 3. Using Aersleep; Charging Aersleep; Before Applying Aersleep; Using Aersleep - Sommetrics aersleep Instructions D'utilisation

Chapter 3. Using aerSleep

Charging aerSleep

™
NOTE: Fully charge aerSleep before each use (approximately four
hours or until the indicator light remains solid
green).
CAUTION
Charge ONLY using the provided USB
cable and wall charger via a standard AC
wall outlet. Do NOT charge by plugging
the USB cable into a computer, laptop or
other electronic device.
1. Connect the USB cable to the wall charger
and the wall charger to the wall outlet
(Figure 1).
2. Connect the USB cable to the USB port on
the pump module (Figure 2).
NOTE: A blinking green indicator light shows
that aerSleep is charging. A solid green
indicator light shows aerSleep is fully charged.
3. Place and store aerSleep in its box while charging or not in use.

Before Applying aerSleep

™
1. Remove any necklaces and earrings that may interfere with aerSleep
sealing.
2. In the area where aerSleep will be placed:
○ Remove facial creams or cosmetics.
○ Ensure skin is clean and dry.
○ Ensure there are no obvious skin rashes or sores.
○ Remove facial hair that prevents aerSleep from maintaining an
airtight seal. Individuals with a heavy beard should shave 3-4 hours
before use.

Using aerSleep

™
NOTE: Fully charge aerSleep before each use
(approximately four hours or until the indicator
light remains solid green).
1. Remove USB cable from the pump module.
2. Turn aerSleep ON by double tapping the
Sommetrics logo (Figure 3).
6
™
Figure 1
Figure 2
Figure 3
NOTE: A solid green indicator light should
appear (Figure 4).
WARNING
A solid amber or solid red indicator light
shows aerSleep is not fully charged.
NOTE: Refer to the aerSleep Indicator Lights
section for additional details.
3. Lie down and keep head in a neutral position.
NOTE: Ensure aerSleep vents are oriented up
towards the jawline and indicator lights are
facing downward.
4. Apply aerSleep:
STEP 1: Hold the sides of aerSleep and
position chin in the chin rest (Figure 5).
NOTE: Ensure there are no obstructions
(e.g. hair, jewelry, clothing, bedding).
STEP 2: Rotate aerSleep inwards until the
upper flange rests on the jawline and lower
flange rests on the neck (Figure 6).
NOTE: Ensure that aerSleep does not touch
your ear(s). You should now feel aerSleep
gently seal.
STEP 3: Confirm a good seal by rotating your
head side to side and up and down (Figure 7).
NOTE: Once aerSleep is applied, an occasional gentle pulsing
sensation may be felt, which indicates a good seal.
NOTE: Acclimation is important for the successful use of aerSleep. It
may take a few days to fully acclimate to wearing aerSleep for an
entire night. Contact Sommetrics' Customer Success department about
possible acclimation techniques.
WARNING
Discontinue use if an airtight seal cannot be obtained. Discontinue
use if you experience extreme discomfort while wearing aerSleep.
For an instructional video on how to properly apply and use aerSleep,
please visit www.sommetrics.com/aersleep-overview.
Figure 4
Figure 5
Figure 6
Figure 7
7