LUXSAR VD460AF-IR Notice

1. GENERAL
The DSP color dome camera VD460AF-IR & VD461AF-IR incorporates advanced 1/3" high
performing CCD Sensor and digital signal processor (DSP) circuit.
VD460AF-IR Color CCD Camera incorporates a varifocal 3,7 ~ 12 mm.
VD461AF-IR Color CCD Camera incorporates a varifocal 2,6 ~ 6 mm lens lens.
High quality picture, aesthetic and easy to install, the VD460AF-IR & VD461AF-IR are good
complement for your line of CCTV system.
2. FEATURES
2.1. Automatic tracing white balance
The color CCD camera VD460AF-IR & VD461AF-IR employ Auto Tracing White
Balance adjustment circuit that adjusts continuously the picture as lighting con-
ditions change for making the correct White Balance adjustment Auto.
2.2. Automatic gain Control (AGC)
The adoption of an Automatic Gain Control (AGC) provides clear image in low
light condition.
2.3. Auto Electronic Shutter (AES)
The color CCD dome camera VD460AF-IR & VD461AF-IR incorporates the Elec-
tronic Shutter up to 1/100,000.
2.4. Back Light Compensation (BLC) - On/Off
As you take a picture with strong light behind the subject, the picture would be
looked very dim on the subject.
In this case, you should select BLC ON, the AES should be in ON position.
NOTE: When you select BLC ON, the AES should be in ON position.
4.2. Step 2
Adjust the camera angel use A & B to get the ideal angel. Adjust the camera
shade angel to match the location of the camera lens.
4.3. Step 3
Place upper cover kit on the top of dome base and screw it by using hex
key wrench.
4.4. Step 4
Complete installation
VD460AF-IR
VD461AF-IR
Color dome camera
Vandal proof
High resolution
2 YEARS WARRANTY
(See conditions of sales abstract)
1
3
2.5. Level adjustment
To adjust the "DC Driver Level Adjustment" you can get the luminosity that
you want for your picture.
3. PRECAUTIONS
3.1. Do not disassemble it or place it on an unstable base.
3.2. Do not touch the surface of CCD sensor by hand directly.
3.3. Never face the camera toward the sun.
3.4. Use proper AC power source otherwise the camera will not function correct-
ly.
3.5. In case the camera with any defect, please inform the qualified service per-
son. Don't try to disassemble the camera by yourself.
4. INSTALLATION PROCEDURE
Camera will be installed as below when Ex-factory
4.1 Step 1
Take out M4 x 16 inner hex socket head screw from upper cover kit by using
3.9 mm hex key wrench then take out the upper cover kit.
5 OVERVIEW
1. Dome Casing
2. 3.9 mm hex key wrench
3. M4 x 16 inner hex socket
head screw
4. Upper cover kit
5. Rubber washer
6. Dome shell
7. PC Ring
8. Cover safety linkage
9. Camera shade
10. Gasket
11. M4 x 4 flat head Phillips
12. Dome base
13. Camera shade
14. Camera assembly
7. SPECIFICATIONS
VD460AF-IR & VD461AF-IR
PICK UP DEVICE
PICTURE ELEMENTS
SYNC SYSTEM
HORIZONTAL RESOLUTION
MINIMUM ILLUMINATION
BACK LIGHT COMPENSATION
WHITE BALANCE
ELECTRONIC SHUTTER
GAIN CONTROL
GAMMA CORRECTION
S/N RATIO
LENS VD460AF-IR
LENS VD461AF-IR
DAY/NIGHT COMMUTATION
VIDEO OUTPUT
POWER SOURCE
POWER CONSUMPTION
STORAGE TEMPERATURE
WORKING TEMPERATURE
WATERPROOFING CRITERION IP66
DIMENSIONS
WEIGHT
Designs and specifications are subject to change without notice
2
1/3" Sony CCD
PAL: 752 (h) x 582 (v)
Internal sync
540 TV lines
0.5 lux @ F2.0
On/Off switch
Auto. White Balance (AWB)
Auto. 1/50 to 1/100 000
Automatic
> 0.45
Over 48dB
3.7 ~ 12 mm @ F2.0 varifocal - DC iris
28° ~ 97° horizontal
2.9 ~ 6 mm @ F2.0 varifocal - DC iris
47° ~ 105° horizontal
IR cut filter removable
1.0 Vp-p, 75 ohm
DC 12 V +/- 10 %
290 mA +/- 10 % under 12 V
-30° ~ + 60° C
-10° ~ + 60° C
137 (w) x 137 (l) x 97 (h) mm
Approx. 700 g
VD460AF-IR & VD461AF-IR-Manuel-V03
4