Airstream TC4-NVS Mode D'emploi page 20

TC4-NVS
1 Specifying the Temperature Curve
Set the selection knob to SET POINT /TEMP. CURVE. The current
temperature set point flashes on the display.
Press the push-button. The word OFF is displayed indicating that the
termperature curve is deactivated. If this is not the case, see below
to deactivate the curve.
Repeat the following steps for each of the six points:
Press the push-button once again. The letter "d" followed by a day
number flashes on the display.
Using the adjustment knob, set the day number to the desired value.
Press the push-button once again. The current temperature set point
flashes on the display.
Using the adjustment knob, adjust the set point to the desired value.
Once the six points of the curve have been specified, activate the curve as
explained below.
NOTE
: Make sure the temperature curve is deactivated before specifying
new points (see below).
Activating the Temperature Curve
2
If you have just finished specifying the points on the curve:
Press the push-button once again. The word OFF flashes on the
display.
20
TC4-NVS.rev.04