FUXTEC FX-RM Serie Mode D'emploi page 67

Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_es_rev23
Clean the device carefully with water after each cutting operation. Remove the grass and mud deposits
that have accumulated inside the undercarriage. This will avoid drying out and possible difficulties when
starting the engine again.
You can use the EASY CLEAN connection to clean the inner housing
(cutting unit). Simply connect a water hose to the connection on the top
of the housing and slowly turn on the water while the cutting mechanism
is running. The rotation of the cutting mechanism distributes the water
evenly in the inner housing and can thus flush away dirt residues.
The paint on the inner side of the undercarriage may flake off over time
due to aggressive operations. In this case, you should paint over the paint with rust-resistant paint to
protect the undercarriage from the corrosion of the metal.
Check the V-belt 1-2 times a year and remove any cuttings from it.
Once a year, the drive wheels should be cleaned inside.
Remove both wheels. Use a brush or compressed air to remove grass and dirt from the gear wheel and
gear rim.
67
Easy Clean
connection