FUXTEC FX-RM Serie Mode D'emploi page 68

Original User Manual FUXTEC FX-RM Series_de_en_fr_ita_es_rev23
27.
CHANGING THE CUTTING BLADES
Remove the screw to replace the blade. Empty the fuel tank before removing the blade.
Replace everything, as shown. Fasten the screw properly. The fastening torque is 45Nm. Also, replace the
blade screw when replacing the blade.
OIL CHANGE
1. Switch off the engine and let it stop completely.
2. Disconnect the spark plug cable and keep it away from the spark plug.
3. Empty the oil into a suitable container. Tilt the lawnmower by 45 degrees and use a FUXTEC suction
pump to suck off the oil through the filler neck. Alternatively, you can tilt the mower more to drain the oil
through the filler neck.
4. Keep the engine balanced. Remove the dipstick. Slowly add approximately 0.5L of new recommended
oil (FUXTEC 4MAX 4 stroke oil) into the container until the dipstick reads the top of the container. Do not
overfill the container.
5. Check the level with the dipstick
68
Care, maintenance, and storage
WARNING: Avoid skin contact
with the oil. Wash your hands
thoroughly with soap and water
after changing the oil.
ATTENTION: Used oil is a
hazardous waste product. We
recommend that you take used oil
to your local disposal center for
proper disposal. Do not dispose of
the device with household waste.