Witter SU28AU Notice De Montage

MATERIALS
A 1 Cross Bar
C 1 Left Sidearm
D 1 Right Sidearm
E 1 Left Stiffener Bracket
F 1 Right Stiffener Bracket
G 6 M12 x 35 x 1.75 Bolt, Lock Washer and Flat Washer (25mm O.D)
J 4 M12 x 35 x 1.75 Bolt, Nuts, Lock Washer and Flat Washer (25mm O.D)
K 3 M10 x 25 x 1.5 Bolt, Nuts, Lock Washer and Flat Washer (20mm O.D)
M 1 Electrical Plate
N 1 Electrical Plate Bracket
FITTING
1. Remove bumper (3 torq screws around each wheel arch, 1 screw, located behind plastic cap on internal boot side trim
(be carfull not to drop inside trim), 2 clips under each light cluster (to remove light cluster, unclip plastic trim to boot side of
lights and undo retaining screws, disconnect bulbs), 4 clips along lower edge of bumper.
2. Remove reinforcement beam and mount brackets (hand to customer) retain the 6 M8 nuts from mounting brackets.
3. Lower exhaust and remove heat shields.
4. Loosely attach Stiffener Brackets (E&F) using M8 nuts retained from reinforcing beam.
5. Insert side arms (C&D) into chassis rails and loosely attach using bolts (G) and (K).
6. Loosely attach Towbar Main frame in lower position using bolts (J). Tighten all bolts.
7. Attach Neck option required and electrical plate angle (N). Attach electrical plate (M) to electrical plate angle (N) using bolt
(K).
8. Drill 2 holes in heat shield in positions marked with dimples, of sufficient size to clear bolt heads (G). Refit heat shield.
9. Cut bumper as shown (protect outer edge of bumper) and refit. Tighten remaining bolts.
Note
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: Grade 8.8 M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
Grade 10.9 M12 – 139Nm
µW0001SU28AU-FIT$011006020000tÄ
W 0001S U 28A U -F IT $011006020000
For Subaru Legacy Outback
For use with 3016 series necks
www.witter-towbars.co.uk
TOWBAR
SU28AU
2003-2009
Issue 1