GoPro HERO 3+ SILVER EDITION Mode D'emploi page 59

aTTaCHInG aDHesIVe MOUnTs
▶See: gopro.com/support for more information on mounts.
locking Plug
HERO3_Plus_Silver_UM_ENG_FRA_REVA.indb 59
Apply to clean surface only. Wax, oil, dirt or other debris will
PrO
reduce adhesion, which can result in a weak bond and risk of
TIPs:
losing camera should connection fail.
Attach mount in room temperature conditions.
Mount's adhesive will not bond properly if applied in
cold or damp environments to cold or damp surfaces,
or if the surface is not room temperature.
Adhesive mounts should only be mounted to smooth surfaces;
porous or textured surfaces will not enable a proper bond.
When applying mount, firmly press into place and ensure
full contact over entire surface.
For best results, attach the mount 24 hours prior to use.
Using the HERO3+ in high impact sports such as surfing or skiing
where significant impact may occur? Use the special Locking Plug
which securely locks the Quick Release Buckle fingers into place,
helping prevent accidental housing release from the mount.
The circular ring fits over the thumbscrew and acts as a leash
to prevent dropping or losing the locking plug.
usInG tHe mounts
59
6/26/13 3:26 PM