Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(For vehicles without existing weldnuts on side frame) – Same Step 1-2 as above
3.
Install hitch – Using pull wire ⑤, feed (2) carriage bolts ① and (2)
spacers ② through access hole as shown in Figure 4 and 5, both sides. Leave pull
wires attached to hardware and leave hardware inside the frame temporarily. Raise
the hitch and feed pull wire previously installed through hitch bracket slot. Remove
pull wires and loosely install conical washer ③ and hex nut ④ to hitch.
©2017, 2021 Horizon Global™ Corp - Printed in Mexico
4.
Tighten the 7/16" fasteners with torque wrench to 50Lb.-Ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5.
Re-install exhaust - Raise exhaust back into position, install the bolts removed from
the hangers earlier.
Sheet 5 of 15
76192NP
03-19-21
Rev. B
Publicité
Table des Matières
