Horizon Global 76192 Instructions D'installation page 4

(For vehicles with existing weldnuts on side frame)
1. Trim bumper fascia – Measure to find the center of the fascia, mark a centerline on
the bottom of the fascia and trim as shown in Figure 2. Mark a centerline on the
vertical portion of fascia and trim as shown in Figure 3 * Do not trim away the bottom
edge. *Dimensions are approximate and may be adjusted for fit and aesthetics*
Figure 2 Bottom View
Figure 3 Rear View
Leave the bottom edge!
3. Install hitch – Raise the hitch into position over the exhaust and forward enough
so that the receiver clears the bottom edge of fascia. Align the holes in the hitch
with the vehicle existing weldnuts and install the bolts removed earlier.
©2017, 2021 Horizon Global™ Corp - Printed in Mexico
2. Lower exhaust and remove existing fasteners – Lower the exhaust by removing (2)
bolts from each rear exhaust hanger bracket (1 per side) with a 13mm socket.
Remove (4) M10x1.5x40mm bolts from the outside of the frame rails (2 per side)
with a 16mm socket.
4. Tighten the M10 fasteners with torque wrench to 53Lb.-Ft. (72 N*M
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Re-install exhaust - Raise exhaust into position, install the bolts removed from the
hangers earlier.
Sheet 4 of 15 76192NP 03-19-21 Rev. B