GE JV535 Manuel Du Propriétaire Et Instructions D'installation page 4

Using the hood controls.
Throughout this manual, features and appearance may vary from your model.
Control Knobs
(on some models)
OFF
LO
MED
HI
FAN
MAX
FAN Control
Turn to LO, MED, HI or MAX as needed.
Continuous use of the fan system while cooking helps
keep the kitchen comfortable and less humid. It also
reduces cooking odors and soiling moisture that create a
frequent need for cleaning.
LIGHT Control
Turn to HI while cooking or to NITE for use as a night light.
Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood.
Filter locks
If it ever becomes necessary to replace
the metal grease filters, they may be
ordered from your GE supplier.
4
OFF
HI
NITE
LIGHT
Reusable Metal Grease Filters
The hood has 2 metal reusable grease
filters.
The metal filters trap grease released
by foods on the cooktop. They also help
prevent flaming foods on the cooktop
from damaging the inside of the hood.
For this reason, the filters must ALWAYS
be in place when the hood is used. The
grease filters should be cleaned once a
month, or as needed.
To remove, press the filter locks back and
pull the filters down and out.
To replace, insert the rear filter tabs
in the frame slots at the back of the
opening. Push the filters up and lock
them into place.
Rocker Switch Controls
HI
OFF
LOW
FAN
FAN Control
Press the rocker switch at the top to turn the fan on HI
and at the bottom to turn it on LOW. The center position is
OFF.
Continuous use of the fan system while cooking helps
keep the kitchen comfortable and less humid. It also
reduces cooking odors and soiling moisture that create a
frequent need for cleaning.
LIGHT Control
Press the rocker switch at the top to turn the light ON
while cooking. Press the rocker switch at the bottom for
use as a night light. The center position is OFF.
To clean the grease filters, soak them
and then swish them around in hot
water and detergent. Don't use ammonia
or ammonia products because they will
darken the metal. Do not use abrasives
or oven cleaners. Light brushing can
be used to remove embedded dirt.
Rinse, shake and let them dry before
replacing. They may also be cleaned in
an automatic dishwasher.
NOTE: Before cleaning, make sure the
charcoal filters, if present, are unclipped
and removed. See the Charcoal Filters
section.
(on some models)
HI
OFF
NITE
LIGHT