Charge Point Installation; Disassemble Logo Cover; Secure Mounting Bracket - Lucid Connected Home Charging Station Mode D'emploi

Charge Point Installation

Disassemble Logo Cover

1. Remove 2x M4 screw with T20H bit.
2. Slide logo cover up and remove by
pulling from charging station housing.
3. Remove 6x M4 screws with T20H bit,
and open the top cover.
Installation
4. Remove 2x M4 screw with T20H bit, and
remove rear mounting bracket.

Secure Mounting Bracket

Secure the main body mounting bracket to the
wall with the appropriate screw.
For the indoor site, ensure that mounting is
not lower than 18" (450 mm) and not higher
than 4' (1.2m). For the outdoor site, please
ensure that mounting is not lower than 24"
(600 mm) and not higher than 4' (1.2m).
Note: It is recommended to use four (4) screws
when mounting the bracket, however if the
preference is to only use two (2), please use
the middle two screw holes of the bracket.If
only two screws are used to fasten the
mounting bracket, the screws should pass
through the middle two screw holes of the
mounting bracket.
12