BOMANN SBS 7308 IX Mode D'emploi page 44

near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Levelling the appliances doors
If the doors are uneven and do not close parallel to
each other, the refrigerator door must be aligned.
Maximum tolerance compensation is 5 mm!
Open the door, loosen the locknut (1) with a
wrench (a)..
if the refrigerator door is too low
..
nut (2) counterclockwise to raise the door.
if the refrigerator door is too high
..
nut (2) clockwise to lower the door.
Once the doors are aligned, retighten the locknut (1).
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
, turn the adjusting
, turn the adjusting
44
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Control panel
GENERAL NOTE:
 About 10 seconds after the last button press, the
control lamps stop flashing and the settings are
activated.
 About 60 seconds after the last button press, the
display will enter the standby mode.
The standby mode is terminated as soon as but-
tons are pressed, or device door is opened.
Control lamps
REF. Temperature indicator fridge
FRZ. Temperature indicator freezer
OFF Fridge operation switched off
Control panel locked for operation
SUPER COOL Super cooling function
activated
SUPER FRZ. Super freezing function
activated
Temperature display