Handle Installation - Power Fist 8642969 Mode D'emploi

V 4.3

HANDLE INSTALLATION

1. Screw the auxiliary handle (7) into one of the three
mounting holes. See figure 1.
2. Attach the rear D-handle (6) to the tool and secure by
tightening the knob.
MIXING PADDLE INSTALLATION
1. Mount the mixing paddle (10) to the mixing
paddle shaft (9).
2. Mount the mixing paddle and shaft to
the spindle. See figure 2.
CAUTION! Remove adjusting keys and
wrenches. Check that keys and adjusting
wrenches are removed from the tool before
connecting it. A wrench or key that is left
attached to a rotating part of the tool
increases the risk of personal injury.
OPERATION
1. Connect the plug to the power source.
2. Insert the mixing paddle (10) into the substances to be
mixed before switching on the tool.
NOTICE! Make sure that the mixing container is securely
positioned on the floor.
3. Press the switch button (3), then squeeze the trigger
switch (2) to rotate the mixing paddle (10). See figure
3. The trigger switch has pressure control to control
the speed that the mixing paddle rotates. The more
that the trigger is squeezed, the faster the mixing pa
ddle will rotate. See figure 4.Gradually increase the
mixing speed by putting more pressure on the trigger
(2).
Visit www.princessauto.com for more information
9A Electric Mixer 8642969
9