Low Voltage - Power Fist 8642969 Mode D'emploi

8642969
6. When operating a power tool outside, use an outdoor extension cord marked "W-
A" or "W". These cords are rated for outdoor use and reduce the risk of electric
shock. Use in conjunction with a Ground Fault Circuit Interrupter (GFCI). If
operating a power tool in a damp location is unavoidable, the use of a GFCI
reduces the risk of electric shock. It is recommended that the GFCI should have a
rated residual current of 30 mA or less.
7. Avoid using an unnecessarily long extension cord. Choose a cord that is
appropriate for the situation, as a cord that is too long and running across the
floor can be more dangerous than helpful. Using a cord that is too long or too thin
could damage the tool. Unroll the cord completely to prevent it from overheating.
8. Place the electrical cord in a position that prevents it from coming into contact
with the tool and from getting caught by the work piece. The cord should always
stay behind the tool.
9. Keep all connections dry and off the ground to reduce the risk of electric shock.
Do not touch the plug with wet hands.
WARNING! People with pacemakers should consult their physician(s) before using
this product. Operations of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.

LOW VOLTAGE

Low voltage may cause overheating due to higher power current being drawn to the tool
that will shorten the motor life.
An extension cord may cause a drop in power to the tool if it is too long or the
amperage rating is not correct. This may result in the following:
1. The tool will not activate when switched on.
2. The tool may switch on, but fails to maintain power when applied to a workpiece.
3. The tool may overheat, possibly starting a fire.
Test the tool by plugging it directly to the power supply. If it powers on, change the
extension cord with the correct rating and as short as needed. The workpiece may also
need to be relocated closer to the power supply.
6
9A Electric Mixer
For technical questions call 1-800-665-8685
V 4.3