Care & Maintenance - Power Fist 8642969 Mode D'emploi

8642969
NOTICE! Be aware of the forces that occur as a result of
jamming. Hold the tool firmly with both hands and take a
secure stance.
4. To make the mixing paddle (10) stop rotating, release
the trigger switch (2).See figure 5.
NOTICE! Switch the tool off only when the mixing paddle is in the mixing container.
Do not remove the mixing paddle from the container while the tool is running.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to control
and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or worn
components. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this tool.
4. Keep the tool handles clean, dry and free from oil/grease at all times.
5. Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An improperly
repaired tool may present a hazard to the user and/or others.
CAUTION! Disconnect the tool from the power source before performing any
maintenance or cleaning.
CLEANING
Once the mixing process has been completed, submerge the mixing paddle in a
container of clean water and turn on the tool. Wipe any remaining substance off of the
mixing paddle with a soft cloth. Use a dry cloth to remove any remaining moisture on
the mixing paddle.
Wipe any substance that has splashed on the tool with a soft cloth. Do not allow any
water to enter the tool.
CAUTION! Do not use any cleaning agents or solvents to clean the tool or
mixing paddle.
Clean the ventilation slots (5) regularly with a brush or compressed air.
10
9A Electric Mixer
For technical questions call 1-800-665-8685
V 4.3