Sending Pictures To The Parrot Df3120; Via Bluetooth; Pairing Your Phone Or Computer With The Parrot Df3120 - Parrot DF3120 Mode D'emploi

: Adjusts the brightness of the display. You can adjust
the screen brightness using the «Select» buttons on
the back of the Parrot DF3120; press the «Enter»
button to confirm.
: Screen saver. Allows you to choose one of the
following options:
- Automatic : the screen's backlight level is
controlled by an algorithm that uses a light sensor
built into the frame. This is the default setting.
- Predefined Time: a predefined time range
determines when the screen is backlit.
You will be prompted to set the time on the
Parrot DF3120.
- Disable: the screensaver, which is triggered
according to the brightness, is disabled.
- Standby mode: triggers the screensaver.
NOTE: TO ExIT THE STANDBY MODE, PRESS ANY BUTTON
OR START A CONNECTION.
: Select the required language.
: Restores the factory settings (doing so does not
delete your photos).

Sending pictures to the Parrot DF3120

1. Via Bluetooth

Prior to use your Parrot DF3120 with your phone / computer
for the very first time, you must initially pair the two
devices. This procedure allows both devices to exchange
information in order to configure a Bluetooth connection.
1.1 Pairing Your Phone or Computer
with the Parrot DF3120
• Ensure that the Parrot DF3120 is adjusted so that it is visible
to all Bluetooth devices. Refer to the «Settings» chapter
in this guide.
• Activate the Bluetooth feature on your phone / computer
(refer to your phone's or computer's user guide or visit
the Support heading on our website at www.parrot.com).
• Search for Bluetooth devices on your phone / computer.
• Select the Parrot DF3120 in the list of Bluetooth devices
proposed by your phone / computer.
• On your phone / computer, enter the code «0000».
• Your two devices are now paired.
13