Preparation For Use; Installing Remote Control Battery; Unit Installation - Nikken Air Wellness Power 5 Pro Manuel Du Propriétaire

Installing remote control battery

A battery (Type CR2025) is supplied with the remote control. This battery must be
installed before the remote control can be used.
1. Open the battery access tray in the remote control by
pushing the end latch inward (the direction indicated)
and sliding the tray out of the remote.
2. Insert the battery in the remote control, making sure
that the battery is correctly positioned with the positive
terminal touching the positive connector.
3. Replace the battery tray.
Follow the same procedure whenever the battery needs to be
replaced. Normal battery life is approximately one year.
Replacement batteries may be purchased at most electronics
stores.
See caution statements at the front of this manual regarding handling and disposal of
the battery.
When using the remote control, operate with front end (signal sender) directed at the
Power5 Pro™ unit. The signal from the remote may be blocked if there is an object

Unit installation

PREPARATION FOR USE

between the remote and the unit.
When the Power5 Pro is first unpacked, some of the materials in the unit may
produce a slight odor. This is normal and occurs during the manufacturing process.
The odor should dissipate after the product has been in use for a few days or weeks,
depending on the amount of use.
If the odor persists, clear debris or dust from the filter components and the air outlet
vent, using a vacuum cleaner. If odor remains after cleaning, replace the filters.
Before use, remove the protective plastic strip from the front panel display and discard.
If filters are sealed in packaging, follow the procedure described in the maintenance
section (page 14) to install them before attempting to operate the unit.
All manuals and user guides at all-guides.com
-9-