Sauder Lateral File 422975 Instructions De Montage page 9

Table des Matières

Publicité

Step 5
Lay the ENDS (A and B) fl at on the fl oor with the HIDDEN CAM surfaces down.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B) until the shoulders of the SCREWS rest on
å
the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (C) onto the ENDS (A and B). Line up the grooves in the MOLDINGS over the heads of the SCREWS
å
in the ENDS.
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
RIGHT END ASSEMBLY
These edges
should be even.
LEFT END ASSEMBLY
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/services
A
C
Shoulder
C
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
422975
32S
(4 used in this step)
Shoulder
B
Page 9

Publicité

Table des Matières
loading

Table des Matières