Publicité
Step 9
Separate the EXTENSION SLIDES (R) from the EXTENSION RAILS (Q) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (Q) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW
into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
1
Open end
www.sauder.com/services
R
GOLD 5/16" FLAT HEAD SCREW
4
3
2
Q
B
2
Q
1
3S
(8 used in this step)
2
Q
3
4
A
4
3
After fastening the EXTENSION RAILS to the RIGHT END (A),
the SAFETY STOPS should touch the top edge of the RAILS.
If the gap is larger than 1/16", the drawers could lock up and
not open. If this happens, open two drawers at the same time
to override the interlock system. Remove the drawers to
re-adjust the INTERLOCK TRACK assembly.
422975
Q
1
1
2
3
4
Open end
Q
SAFETY STOP
Page 13
Publicité
