Publicité
Step 20
Flip a drawer over onto the left DRAWER SIDE (D225).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in a EXTENSION SLIDE (R). You may need to
å
insert one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the EXTENSION SLIDE (R).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly
å
seated in the slots.
Now, fasten the EXTENSION SLIDE (R) to the right DRAWER SIDE (D225). Use two GOLD 5/16" FLAT HEAD
å
SCREWS (3S) through holes #2 and #4.
Repeat this step for the other drawer.
å
1.
R
20G
These tabs must
insert into the slots.
Post
2.
R
Page 24
Slot
3
4
D225
D225
20G
Seated
Open end
R
1
2
3.
422975
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Publicité
