Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION PROCEDURE / STEP 8 / STEP 9 / STEP 10
Use 1 1/2" pan head screws to anchor
8
wall bumper and bumper guide into
center hole on each side.
Measure opening at top of wall jamb,
9
cut top track (1) 1/16" shorter than opening.
10
Place top track down over wall jambs as
shown.
INSTALLATION PROCEDURE / STEP 11
Install outer door panel by lifting up & into top track (1)
11
(Do not lift by towel bar, be careful not to bump
panel against metal track.)
1 1/2" PAN HEAD SCREW
- 6 -
Publicité
Table des Matières
