Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION PROCEDURE / STEP 1
Attach rollers to hanger clips on both panels. Rollers should be mounted so that the head of the
1
mounting screw is on the same side of the panel as the screw head set into the hanger clip (see inset
drawing). Inner panel must be on the same side of your shower as the shower head. If your shower head
location requires you to reverse the panels, you will need to install the rollers on the opposite
side of the hanger clip and flip the panels around to create the proper orientation. In this case, you
should ignore the labels that says "rollers belong on this side".
NOTE: The various holes in the hanger clip are used to fine tune the adjustment of the panel to make
up for walls that are slightly out of square or plumb. For best results start with all rollers in the second
hole from the top and then make adjustments as needed.
- 3 -
Publicité
Table des Matières
