HUROM H-101 Serie Manuel D'instructions page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

17
Using Power Dial / When Screw Stops in Use
Using Power Dial
① Turn to right (clockwise) to 'Extract', set in the middle to 'Stop', and turn to left (counterclockwise) to 'Reverse'
② For safety, the machine will not stop instantly but slow down to a stop when you set the dial to Stop [ ].
③ Reverse [REV] feature is active when you are holding the dial on [REV]. (Stops when you remove your hand.)
Screw Stops in Use
 The screw may stop if you put ingredients too much or too quickly.
 If the machine does not resume even after the following remedies, turn off the machine and contact
Hurom Customer Center.
1
Turn the power dial to the direction of [REV] and hold it for 3~5 seconds (counterclock-
wise) and let it go. repeat this 2-3 times.
The "Reverse" feature pushes the ingredients in the chamber upwards. The "Reverse" feature is active
when you are holding the dial and stops when you remove your hand.
2
when the reverse motion comes to a complete stop, turn the power dial to the direction
of [on] (clockwise) to run.
When turning power dial to the direction of [ON] or [REV], make sure the screw comes to a complete stop
first before turning the dial to the direction of your choice.
4DC010729 사용설명서 H-101 Series(A2) 영불(cTUVus)_V.01.indd 17
2018-09-11 오후 1:12:37

Publicité

Table des Matières
loading

Table des Matières