Sauder 411905 Instructions D'assemblage page 11

Tête de lit, lit de 1 place
Table des Matières

Publicité

Step 7
Before fastening the FLIP-UP DOOR to your unit, be sure
å
the mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the mounting screw to slide
it against the stops. Then tighten the mounting screw.
Fasten the FLIP-UP DOOR (J) to the SMALL SHELF (H)
å
as shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
NOTE: The top edge of the DOOR and the top surface of
å
the SMALL SHELF should be even.
Fasten the KNOB (W) to the FLIP-UP DOOR (J). Use a
å
BLACK 1-1/8" MACHINE SCREW (Z).
See step 9 for DOOR adjustments.
å
www.sauder.com/services
Mounting
screw
Z
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
411905
Want options? Customize
your item with add-on
hardware kits available
on sauder.com.
Hinge
Stop
J
H
W
Page 11

Publicité

Table des Matières
loading

Table des Matières