Plebani Fast Mode D'emploi page 28

ADAPTOR PILLOW REMOVING
"FAST" is equipped with an adaptor pillow to use when your child is small. When baby
grows it's recommended to remove it.
On its back side there are two Velcro strips at the height of the belts' holes (Fig. 22). To
remove the pillow, loosen belts (Fig. 14) while sliding separating the buckles (Fig. 15, 16
and 17), lower the top of the pillow folding it onto itself (Fig. 23).
Detach the Velcro (Fig. 24) on both sides. Gently pull the adaptor pillow (Fig. 25) until it's
completely removed. Re-insert belts into buckle (Fig. 19 and 20).
CAR-SEAT POSITION ADJUSTMENT
"FAST" car-seat is adjustable in 3 different positions (Fig. 26) for better comfort of your
baby during the trip. To adjust positions, press and hold the lever under the seat and pull
or push seat until the desired position, releasing lever.
CORRECT BELT POSITION
Pay attention to the position of seat belts; make sure they are in the correct position and
close to the body.
Belts should not be placed too high or too low than your child (Fig. 27).
BELTS POSITIONS REGULATION
To adjust "FAST" harness at correct height, we suggest you to place car-seat in its lowest
position (Fig. 26 III).
Loosen harness (Fig. 14) and take them out from the back of the back of car-seat (Fig.
28).
Bring right belt and pull it out from the metal bracket (Fig. 29); make same operations for
the left belt (Fig. 30).
Pull belts out from fabric loops of the seat and insert them into the appropriate position to
your child's height (Fig. 31). Re-insert belts into metal clamp (Fig. 32 and 33). Pull, and
tighten car-seat belts (Fig. 21) taking care that they do not jam or become twisted inside
the body of the car-seat.