Ego Power+ STX3800 Traduction De La Notice D'origine page 15

TROUBLESHOOTING
PROBLEM CAUSE
◾
◾
Fail to start
◾
◾
◾
◾
Stop working
◾
◾
◾
◾
◾
◾
◾
The cutting line
can't be released.
◾
◾
The battery pack is not attached
to the line trimmer.
No electrical contact between
the trimmer and battery.
The battery pack is depleted.
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
Heavy cutting line is used.
The motor shaft or trimmer head
is winded with grass.
The motor is overloaded.
The battery pack or line trimmer
is too hot.
The connector of battery pack is
disconnected from the tool.
The battery pack is depleted.
The motor shaft or trimmer head
is wound with grass.
There is not enough line in the
trimmer head.
The trimmer head is dirty.
Line is tangled in the trimmer
head
The line is too short.
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX3800
SOLUTION
◾
Attach the battery pack to the line trimmer.
◾
Re insert the battery pack with the specified
charger.
◾
Charge the battery pack.
◾
Unplug the battery connector from the socket and
mount the guard on the trimmer.
◾
Use recommended nylon cutting line with diameter
no greater than 2.4mm.
◾
Stop the trimmer, remove the battery, and remove
the grass from the shaft and trimmer head.
◾
The machine will recover when the load is
removed. For continuous working, reduce the load
of the machine.
◾
Allow the battery pack or trimmer to cool until the
temperature drops below 67°C.
◾
Re-plug in the connector again.
◾
Charge the battery pack.
◾
Stop the trimmer, remove the battery and remove
the grass from the motor shaft and trimmer head.
◾
Remove the battery and replace the cutting line;
follow the section "LINE REPLACEMENT" in this
manual.
◾
Remove the battery and clean the lower cover
assembly, spool and upper cover.
◾
Remove the battery, remove the line from the
spool and rewind; follow the section "LINE
REPLACEMENT" in this manual.
◾
Remove the battery and pull the lines while
alternately pressing down on and releasing the
trimmer head.
EN
15