Accessories - Leister LE 5000 DF-R Instructions D'utilisation

Connection
• The air heater must be connected by qualified personnel.
• A suitable device for full disconnection from the mains must be provided in the mains connection!
• It must be ensured that the connection lines do not come into contact with the heating element tube and are not
exposed to the hot air jet.
• Only the installed temperature-resistant special cord may be used for the electrical connection.
• The power supply cord may only be replaced by a qualified expert or a Leister service centre.
• It must be ensured that the power supply cord is protected against mechanical strain when routing it.
• The device must be connected in accordance with the connection on page 5 (Wiring Diagram) of the operating
instructions.
• Connect air heater to the electrical mains.
• It must be ensured that the hot air can flow out freely, as otherwise the device can be damaged by the excess
heat building up (risk of fire!).
• Attention: comply with minimum air volume and maximum air temperature as per technical data.
• Switch on mains.
• Allow device to cool down after heating mode.
Training
Leister Technologies AG and its authorised service points provide free courses in the area of applications.
3D drawings
• 3D drawings are available from your service point or at www.leister.com

Accessories

• Only Leister accessories may be used.
• Leister offers a wide range of accessories, e.g.
– Temperature controller
– Solid state relay (SSR)
– Nozzles
– Reflectors
• Accessories at www.leister.com
Service and repairs
• Repairs should only be carried out by authorised Leister Service Centres. They guarantee a correct and reliable
repair service within reasonable period, using original spare parts in accordance with the circuit diagrams
and spare parts lists
Warranty
• For this tool, we generally provide a warranty in accordance with the statutory / country-specific regulations
from the date of purchase (verified by invoice or delivery document). Damage that has occurred will be corrected
by replacement or repair. Heating elements are excluded from this warranty.
• Additional claims shall be excluded, subject to statutory regulations.
• Damage caused by normal wear, overloading or improper handling is excluded from the guarantee.
• Warranty claims will be rejected for tools that have been altered or changed by the purchaser.
12