Installation; Safety Instructions For Installation; Preparing For Installation - Inventum MK010 Manuel D'utilisation

Item
Slider
Down button
Function button
Quick-preheat button
Delayed-start button
Timer/child-lock button
Microwave button
Cancel button
Note:
You can use both the up/down button or the slider to adjust the settings of the appliance. All three
buttons have the same function.
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION

• Safety during use can only be guaranteed if installation was done correctly and according to the instructions. The
installer is liable for damage caused by incorrect installation.
• The electrical installation must be carried out by a qualified electrician. The electrician must comply to national
and local regulations.
• The appliance has protection class I and may only be used in combination with an earthed connection.
• The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Make sure that the mains cable does not get jammed during installation or is running along sharp edges. The
mains cable must be placed in such a way that no contact is made with hot parts of the appliance.
• The connection point, mains socket and/or mains plug must always be accessible.
• The kitchen furniture in which the appliance is installed must be heat resistant to at least 90°C. This also applies
to the doors or front of the furniture.
• Make sure that the kitchen furniture in which the appliance is installed is firmly attached, for example by fastening
the furniture to adjacent elements.
• In case of incorrect installation or connection the warranty becomes invalid.
• Changes to the appliance, including replacing the mains cable, must be carried out by a certified installer.
• Make sure that there is sufficient ventilation and fresh air around the appliance.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.

PREPARING FOR INSTALLATION

(Figure 3)
(*) The minimum dimension for B1 is 585 mm and the maximum dimension is 595 mm.
Function
To adjust the settings.
Touch and hold the slider to the left to decrease the
setting.
Touch and hold the slider to the right to increase the
setting.
To adjust the settings.
To select a function.
To select the quick-preheat function.
To select the delayed-start function.
To use the timer or to activate/deactivate the child lock.
To select the microwave function.
To cancel a function or program.
English • 35