Installation; Safety Instructions For Installation; Preparing For Installation; Installing The Appliance - Inventum IMC3834GT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Item
Function button
Microwave button
Note:
You can use both the up/down button or the slider to adjust the settings of the appliance. All three
buttons have the same function.
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety during use can only be guaranteed if installation was done correctly and according to the instructions. The
installer is liable for damage caused by incorrect installation.
The electrical installation must be carried out by a qualified electrician. The electrician must comply to national
and local regulations.
The appliance has protection class I and may only be used in combination with an earthed connection.
The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
Make sure that the mains cable does not get jammed during installation or is running along sharp edges. The
mains cable must be placed in such a way that no contact is made with hot parts of the appliance.
The connection point, mains socket and/or mains plug must always be accessible.
The kitchen furniture in which the appliance is installed must be heat resistant to at least 95°C. This also applies
to the doors or front of the furniture.
Make sure that the kitchen furniture in which the appliance is installed is firmly attached, for example by fastening
the furniture to adjacent elements.
In case of incorrect installation or connection the warranty becomes invalid.
Changes to the appliance, including replacing the mains cable, must be carried out by a certified installer.
Make sure that there is sufficient ventilation and fresh air around the appliance.
The appliance must be placed equal or higher than 850 mm above the floor.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.

PREPARING FOR INSTALLATION

(Figure 3)
Note:
Make sure that the kitchen furniture is prepared according to the dimensions of the appliance.

INSTALLING THE APPLIANCE

Preliminary requirements
Make sure that the kitchen furniture is prepared according to the correct dimensions.
Function
To select a function.
To select the microwave function and set the microwave
power.
English
31

Publicité

Table des Matières
loading

Table des Matières