SPORTSTECH F26 Mode D'emploi page 20

RUNNING BELT ADJUSTMENT
The running belt is adjusted at the factory; it may come loose during transportation and from
use. After prolong use of running, the belt will stretch out. If the running belt is shifting to the
left, turn on the Power Switch of treadmill and let the running belt run at the speed of 2-
3km/h. Using the Hex Wrench(6), turn the left Belt Adjust Bolt 1/4 turn in the clockwise
direction. You should see the belt start to correct itself by moving back toward the center.
Repeat the above procedure until the running belt is centered. If the running belt is shifting to
the right, turn on the Power Switch of treadmill and let the running belt run at the speed of 2-
3km/h. Using the Hex Wrench, turn the right Belt Adjust Bolt 1/4 turn in the clockwise
direction. You should see the belt start to correct itself by moving back toward the center.
Repeat the above procedure until the running belt is centered.
If the running belt is slipping during use, turn off and unplugged the treadmill. Using the Hex
Wrench, turn both left and right Belt Adjust Bolts 1/4 turn in the clockwise direction for the
same distance, turn on the Power Switch of treadmill and let the running belt run at the speed
of 2-3km/h. You should now walk on to the running belt to determine if the running belt is still
slipping. Repeat the above procedure until the running belt is not slipping.