hestan KRP Serie Manuel D'installation page 13

LOCATION AND INSTALLATION
ELECTRICAL AND WATER CONNECTION (continued)
KRP MODELS
Front of appliance
1
2
ALL OTHER MODELS
Electrical connection
Water connection
Back of appliance
Electrical connection
Operate as follows:
Unwind the electric cable and connect it directly to the wall socket .
Make sure the appliance is in the Stand-by condition and that all lights
are off; if not, press the Unit button
Connect the water line to the threaded connection at the base of the
unit.
1
Fit the other end of the hose to the water tap, use the gaskets provided
in the Owner's Kit.
2
Firmly tighten with ngers - a tool/wrench should not be needed to
make a proper seal. Turn on the water and ensure all connections are
not leaking prior to pushing the unit into the opening.
Back of appliance
Operate as follows:
Unwind the electric cable and connect it directly to the wall socket.
Make sure the appliance is in the Stand-by condition and that all
lights are off; if not, press the Unit button
Push the 1/4" source waterline fully into the elbow connector then
thread the elbow adapter to the solenoid at the back of the appli-
ance.
Firmly tighted with ngers - a tool or wrench should not be needed
to make a proper seal. Turn on the water and ensure all connections
are not leaking prior to pushing the unit into the niche.
(continued)
Water connection
to switch it off.
to switch it off.
©2018 Hestan Commercial Corporation
EN
11