Techno Line WS8017 Mode D'emploi page 14

 Press "ALARM" button to confirm your setting, the hour display of the Alarm 2 time starts to flash.
Press the "UP" or "DOWN" button to set the required hour.
 Press "ALARM" button to confirm your setting, the minute display of the Alarm 2 time starts to flash.
Press the "UP" or "DOWN" button to set the required minute.
 Press "ALARM" button to confirm your setting, the repeat icon "S-S" of the Alarm 2 time starts to
flash. Press the "UP" or "DOWN" button to set the alarm repeat in "M-F" or "S-S" or "M-F" and "S-
S".
 Press "ALARM" button to confirm your setting, the snooze time of the Alarm2 starts to flash. Press
the "UP" or "DOWN" button to set the minute of snooze you need.
 Press "ALARM" button to confirm your setting and to end the setting procedure.
Notes:
 After 20 seconds without pressing any button the clock switches automatically from setting mode to
Normal clock mode.
The alarm is repeatedly set to M-F, the alarm function will be activated from Monday to Friday, the
Saturday and Sunday will be invalid. The alarm is repeatedly set to S-S, and the alarm function will
be activated on Saturday and Sunday, and will expire from Monday to Friday. When the alarm is
repeatedly set to display both M-F and S-S, the alarm function will be activated throughout the
week.
 The snooze time setting range: 5 ~ 60MIN, OFF – there is no snooze function when set to OFF.
Snooze time unit is minutes.
Activate or deactivate the alarm
 Press "ALARM" button can switch the display ALARM1 time or ALARM2 time, in the alarm1 or
alarm2 display mode, press the "UP" button to turn the alarm on or off.
 The alarm 1 or alarm 2 turn on, the "
is open, The repeat of alarm icon at the same time is also displayed.
 The alarm 1 or alarm 2 turn off, the"
is close.
Notes:
 The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case
the alarm will be repeated automatically after 24 hours.
 Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm
signal is heard.
Stop the alarm signal
 During the alarm sound, press any button to stop the alarm.
Snooze function:
 When the time is up to the alarm, touch "SNOOZE", the alarm signal stops, and enter the SNOOZE
mode. After the snooze time is counted, the alarm will ring again.
 In snooze mode, press any button buttons or touch "SNOOZE" and hold for more than 2 seconds to
exit the snooze mode.
Notes:
When the snooze function is set to OFF, when the time is up to the alarm, touch the "SNOOZE"
character position does not have this snooze function.
Temperature & Humidity Detection:
 Temperature measuring range: -9.9°C (+14°F) ~ +50°C (+122°F), LL °C(°F) will displayed if value
lower than -9.9°C (+14°F), HH °C(°F) will displayed if value higher than +50°C (+122°F).
 Humidity measuring range: 20%RH ~ 95%RH, 19%RH will displayed if value lower than 20%RH,
96%RH will displayed if value higher than 95%RH.
" or " "icon is displayed, the alarm 1 or alarm 2 function
" or " "icon disappears, the alarm 1 or alarm 2 function
EN6